Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-55Lines and Trunks
3
◆ Block Procedure
Console/Display Instructions Additional Information PC
! Specify the block of 20 lines associated with the 20 line buttons on the system
programming console.
Select
/LQHV 
/LQHV 
/LQHV 
/LQHV 
! Specify touch-tone or rotary signaling for each block.
Toggle the green LED on or off as required.
On = touch-tone
Off = rotary
! Return to the System Programming menu.
Select
([LW three times.

Rotary Trunk Digit Transfer 3
Use this procedure to designate whether dialed digits on rotary-dial lines/trunks
are sent one by one as they are dialed (no delay), or are stored and sent when
dialing is completed (delay). Contact your service provider for more information
about the appropriate setting.
Summary: Rotary Trunk Digit Transfer 3
Programmable by System Manager
Mode All
Idle Condition Not required
Planning Form Form 8a, System Features
Factory Setting No Delay
Valid Entries Delay, No Delay
Inspect No
Copy Option No
Console Procedure
2SWLRQV→More→5RWDU\→Select option→(QWHU→([LW
PC Procedure

→→→Select option→→

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English