Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-272Extensions
3
Console Display/Instructions Additional Information PC
! Specify the extension.
! Save your entry.
Select
(QWHU.

If you get the Station Busy message, wait for an
idle condition or exit system programming and try
again later.
! Assign the extension. ● ◆
l
Single Line/Trunk Procedure
Console Display/Instructions Additional Information PC
! Specify entry mode.
Select
(QWU\0RGH.

! Enter the line or trunk number.
$VVLJQ/LQHV7UXQNV
If no DSS is attached:
(QWHUH[WHQVLRQ
SP: “Entering an Extension”
Ã
If DSS is attached:
Toggle the red LED on or
%DFNVSDFH
off as required. Go to Step 5.
([LW (QWHU
On = extension is assigned to
trunk or pool.
Off = extension is not assigned
to trunk or pool.
([WHQVLRQ YYYY  
xxxx = extension number entered in Step 3
$VVLJQOLQHVWUXQNV
/LQHV (QWU\0RGH
For a single line/trunk, go to
/LQHV
● Single Line/Trunk Procedure.
/LQHV
/LQHV
For a block of lines, go to
([LW
◆ Block Procedure.
([WHQVLRQ YYYY  
xxxx = extension number entered
(QWHUOLQHWUXQNQXPEHUV
in Step 3
'HOHWH
%DFNVSDFH 1H[W
([LW (QWHU
Dial or type [ nnn ].
Ã

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English