MERLIN LEGEND Communications System Release 6.1
System Programming Guide
555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-310Computer Telephony Integration (CTI) Link
3
Not on MLX Port Module 3
This message appears if you have chosen an extension that is not on an MLX
Port Module. CTI link extensions cannot be programmed on tip/ring or analog
multiline extension module ports. You must chose an extension that is on an MLX
port module (008 MLX or 408 MLX).
Extension Selected Is System Programming Port 3
This message appears if you have chosen an extension that has been
programmed as a system programming port, which is not permitted as the CTI link
port. You must choose another port for the CTI link extension.
NOTE:NOTE:NOTE:
You should choose a module other than the one that has the system
programming port so that you can still perform maintenance and system
programming when the board with the CTI link extension is busied-out.
MLX Port Module Contains Firmware Vintage 29 3
This message appears when the port that you are programming as the CTI link is
on an MLX module with firmware vintage 29. Modules with this firmware vintage
do not work correctly with the CTI link. You must either choose a port on a board
with firmware vintage other than 29 or replace the module with a module that has
a firmware vintage other than 29.
&7,/LQN([WHQVLRQV
([WHQVLRQ
YYYY
)DLOHG
1RWRQ0/;3RUW0RGXOH
([LW
&7,/LQN([WHQVLRQV
([WHQVLRQ
YYYY
)DLOHG
([WHQVLRQ6HOHFWHGLV
6\VWHP3URJUDPPLQJ3RUW
([LW
&7,/LQN([WHQVLRQV
([WHQVLRQ
YYYY
)DLOHG
0/;3RUW0RGXOH&RQWDLQV
)LUPZDUH9LQWDJH
([LW