Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-344Optional Extension Features
3
Console Display/Instructions Additional Information PC
! Go to the third screen of the Extensions menu.
! Select Trunk to Trunk Transfer.
! Specify the extension.
! Assign or remove trunk-to-trunk transfer from the extension entered in Step 4.
Select
(QWHU to allow trunk-to-trunk transfer or

'HOHWH to disallow trunk-to-trunk transfer.

You may continue to assign or remove
trunk-to-trunk transfer from additional extensions
by repeating Steps 4 and 5.
! Return to the System Programming menu.
Select
([LW twice.

([WHQVLRQV!
0DNHDVHOHFWLRQ
/LQHV7UXQNV 5HVWUFW&RS\
/LQH&RS\ $FFRXQW
'LDO2XW&G %,6+)$,
5HVWULFWLRQ &DOO3LFNXS
([LW 9RLFH6LJQO
Press More twice.

([WHQVLRQV!
0DNHDVHOHFWLRQ
7UN7UDQVIHU 6HUYLFH2EV
&RYHU'HOD\
+RW/LQH
'LVSOD\3UHI
([LW

7UXQNWR7UXQN7UDQVIHU
If no DSS is attached:
(QWHUH[WHQVLRQ
SP: “Entering an Extension”
If DSS is attached:
'HOHWH
Toggle the red LED on or
%DFNVSDFH
off as required. Go to Step 6.
([LW (QWHU
On = trunk-to-trunk transfer is enabled.
Off = trunk-to-trunk transfer is disabled.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English