Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-387QCC Optional Features
3
Message Center Operation 3
Use this procedure to designate one or more QCC operator positions to operate
as a message center. The following options are automatically set for the message
center position:
■ Incoming calls are not directed to this position.
■ Returning calls are directed to this position (return from extending and
operator parked calls).
■ All group coverage calls are directed to this position.
■ All DID calls to invalid destinations are directed to this position.
Designating message center operation does not change any call type option
programming, except that the call types mentioned above are added to the calls
received at the QCC Message Center.
Summary: Message Center Operation 3
Programmable by System Manager
Mode Hybrid/PBX
Idle Condition Not required
Planning Form Form 6a, Optional Operator Features
Factory Setting Not applicable
Valid Entries QCC extension numbers
Inspect Yes
Copy Option No
Console Procedure
2SHUDWRU→4XHXHG&DOO→0VJ&HQWHU→Dial ext. no.→
(QWHU→([LW→([LW→([LW
PC Procedure

→→→Type ext. no.→

→→
Procedure: Message Center Operation 3
Console Display/Instructions Additional Information PC
! Select the Operator menu.
6\VWHP3URJUDPPLQJ!
0DNHDVHOHFWLRQ
6\VWHP ([WHQVLRQV
6\V5HQXPEHU 2SWLRQV
2SHUDWRU 7DEOHV
/LQHV7UXQNV $X[(TXLS
([LW 1LJKW6UYFH


Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English