Lucent Technologies MERLIN LEGEND Release 6.1 System Programming

MERLIN LEGEND Communications System Release 6.1
System Programming Guide 555-661-111
Issue 1
August 1998
Programming Procedures
Page 3-388QCC Optional Features
3
Console Display/Instructions Additional Information PC
! Select Queued Call.
! Select Message Center.
! Specify the QCC operator extension.
! Assign or remove the extension as a message center.
Select
(QWHU or

'HOHWH.

You may continue to assign or remove
extensions as a message center by repeating
Steps 4 and 5.
! Return to the System Programming menu.
Select
([LW three times.

6\VWHP2SHUDWRU
0DNHDVHOHFWLRQ
3RVLWLRQV
4XHXHG&DOO
+ROG7LPHU
'/&+ROG
([LW

4XHXHG&DOO2SHUDWRU!
0DNHDVHOHFWLRQ
+ROG5WUQ ,Q4XH$OHUW
+ROG5HOHDVH &DOO7\SHV
7KUHVKROG 0VJ&HQWHU
(OYDWH3ULRU ([WQG&RPSOW
([LW 5HWXUQ5LQJ

2SHUDWRU0HVVDJH&HQWHU
If no DSS is attached:
(QWHU4&&RSHUDWRU
SP: “Entering an Extension”
Ã
H[WHQVLRQQXPEHU
If DSS is attached:
'HOHWH
Toggle the red LED on or off as required.
%DFNVSDFH
([LW (QWHU
On = extension is message center position.
Flashing = extension is not message
center position.
Off = extension is not an operator position.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English