Luna 4600 - Page 150

138 Chapter 7
Controlling the OBR Remotely
7
7
Description: Sets the OBR Integration Area start in the units set by
CONF:XUNI (page 139).
[In Sensing mode, this sets the Sensing Area start, also in
the units set by CONF:XUNI.]
Response: None.
Note: Setting the Integration (or Sensing) start will cause the
Integration (or Sensing) center to be adjusted to match the
new Integration (or Sensing) start and the Integration
Width (or Sensing Range) set using the CONF:INTW
command.
CONFigure:INTegrationStart?
Usage: CONF:INTS?
Description: Retrieves the OBR Integration (or Sensing) Area start in
the units set by CONF:XUNI (page 139).
Response: Returns the OBR Integration (or Sensing) Area start.
CONFigure:INTegrationCenter
Usage: CONF:INTC {integrationCenter}
Description: Sets the OBR Integration (or Sensing) Area center in the
units set by CONF:XUNI (page 139).
Response: None.
Note: Setting the Integration (or Sensing) Area center will cause
the Integration (or Sensing) Area start to be adjusted to
match the new Integration (or Sensing) Area center and
the Integration Width (or Sensing Range) set using the
CONF:INTW command.
CONFigure:INTegrationCenter?
Usage: CONF:INTC?
Description: Retrieves the OBR Integration (or Sensing) Area center
in the units set by CONF:XUNI (page 139).
Response: Returns the OBR Integration (or Sensing) Area center in
the units set by CONF:XUNI.
CONFigure:SENSing
Usage: CONF:SENS { 0 ot 1}
Description: Turns sensing mode On (1) or Off (1)
Response: None.