30 Chapter 3
Software Guide
>Set Logging Options calls up a dialog box where the user may set the
directory and filename prefix for logged data.
• Fast
Scanning:
> Fast Scanning Enabled turns on (checked) and off (unchecked) fast
scanning. See “Fast Scan Mode” on page 44.
> Set Fast Scan Rate calls up a dialog box for setting the scan rate, as
described further under “Fast Scan Mode” on page 44.
•
Sensing:
> Sensing Enabled turns on (checked) and off (unchecked) distributed
sensing, if this option was purchased. Otherwise this menu item will be gray.
(See “Distributed Sensing Measurements” on page 48.)
• > Temperature and Strain Coefficients calls up a dialog box
where the user can change the values used to convert from spectral
shift to temperature change and strain. For more information,
“Temperature Change and Strain Coefficients” on page 49.
• Lower
Graph:
> One Plot, when checked, means one parameter at a time will be plotted
in the lower graph.
> Two Plots, when checked, brings up two parameter selection menus in
the lower graph area. For more information, “Displaying Two Parameters
in Lower Graph” on page 66.
• Color Palette calls up a dialog box allowing the user to specify the
colors for each graph. These changes may be saved for future times
the software is used (by clicking Save), or only be applied to the
current use of the software (by clicking Apply). Clicking Reload
Defaults allows the user to go back to the original software set-
tings.
• Remote Interface Setup calls up a dialog box to set up remote con-
figuration. For more information, see Chapter 7‚ “Controlling the
OBR Remotely,” on page 119.
The Tools menu
• Turn Laser OFF or ON allows the user to turn the laser on or off
from the OBR control software.
To Next Page
Loading...
