Luna 4600 - Page 172

158 Chapter 7
Controlling the OBR Remotely
CONF:SRBW?
Retrieves the spatial Resolution Bandwidth in millimeters.
141
CONF:SRFW
Sets the Spatial Resolution Filter width (ns).
142
CONF:SRFW?
Retrieves the Spatial Resolution Filter width in
nanoseconds.
142
CONF:SSPA
Sets the Sensor Spacing in cm.
138
CONF:SSPA?
Retrieves the Sensor Spacing in cm.
139
CONF:STAR
{startWavelength}
Sets the startWavelength (nm) for the scan.
133
CONF:STAR? Queries the OBR for the current start wavelength (nm). 133
CONF:XUNI
Sets the x-axis units being used to specify the Integration (or
Sensing) Area.
0 : nanoseconds
1 : meters
2 : feet
3 : inches
4: millimeters
139
CONF:XUNI?
Queries the x-axis units being used to specify the Integration
(or Sensing) Area
.
0 : nanoseconds
1 : meters
2 : feet
3 : inches
4: millimeters
139
Data capture and retrieval commands Page
FETC:FDET?
{trace, graphType,
decimate}
Retrieves additional detail for the frequency domain curves:
integrated insertion loss (dB) for graphType = 0, and average
delay (ns) for graphType = 1 or 2.
152
FETC:FREQ?
{trace}
Queries the OBR for the starting frequency and the increment
size, both in units of GHz, for the trace specified (A-E).
144
Table 7-1: Alphabetical Summary of GPIB and TCP/IP Commands
7