214658 141 Revision A
6.4 Lubrication
6.4.1 Lubricating the Header
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
• Use the recommended lubricant specified in the pick-up header operator’s manual.
• Wipe grease fittings with a clean cloth before greasing, to avoid injecting dirt and grit.
• Inject grease through fitting with grease gun until grease overflows fitting, except where noted.
• Leave excess grease on fitting to keep out dirt.
• Replace any loose or broken fittings immediately.
• If fitting will not take grease, remove and clean it thoroughly. Also clean lubricant passageway. Replace fitting if
necessary.
PREDELIVERY INSPECTION
To Next Page
Loading...
