MacDon PW8 - Adjusting Front Draper Belt Tension

214658 138 Revision A
6.3.1 Adjusting Front Draper Belt Tension
1011929
Figure 6.128: Front Deck Adjusting Bolt
Locations
Draper belt tension is factory-set, but it should be checked
before operating.
1026246
A
A
Figure 6.129: Stepped Position Indicators
The stepped position indicator gauges are used to precisely
align each side of the front and rear decks. Each notch (A)
represents an adjustment of 1 mm (3/64 in.).
1026342
A
B
Figure 6.130: Left Side Front Deck Shown –
Right Side Opposite
1. Loosen three clamp bolts (A) on each side of
the header.
2. Loosen jam nut (B) on the left side.
PREDELIVERY INSPECTION