MacDon PW8 - Attaching to New Holland CR;CX Series Combine

214658 62 Revision A
5.3 Attaching to New Holland CR/CX Series Combine
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
1006706
A
B
Figure 5.18: Feeder House Locks
1. Pull handle (A) on combine to raise hooks (B) on both
sides of the feeder house.
1006642
B
A
Figure 5.19: Header on Combine
2. Drive combine slowly up to header until feeder house
saddle (A) is directly under header top beam (B).
3. Raise feeder house to lift header, ensuring feeder
house saddle (A) is properly engaged in header frame.
ATTACHING HEADER TO COMBINE