214658 71 Revision A
5.5 Removing Deck Shipping Braces
Figure 5.39: Shipping Support
DANGER
To avoid bodily injury or death from unexpected startup
of machine, always stop engine and remove key from
ignition before leaving operator’s seat for any reason.
1. Start combine.
2. Relieve load on support bolts (A) and (B) by raising and
lowering the feeder house until bolts are loose.
3. Shut down combine.
4. Remove bolts (A) and (B) and remove support (C).
5. Similarly remove support from opposite end of header.
ATTACHING HEADER TO COMBINE
To Next Page
Loading...
