214658 90 Revision A
Figure 6.37: Case IH Combine Display
6. Select YES (A) from the REEL FORE-BACK list (if
applicable).
7. Set HEIGHT SENSITIVITY (B) to desired value. The
recommended starting point is 180.
Figure 6.38: Case IH Combine Display
8. Select YES for FORE-AFT CONTROL (A) and HDR
FORE-AFT TILT (B) (if applicable).
Figure 6.39: Case IH Combine Display
9. Select the HEAD2 tab at the bottom of the page.
10. Ensure PICKUP (A) is selected from the HEADER
TYPE list.
NOTE:
If the recognition resistor is plugged into the header
harness, you will not be able to change the header type.
11. Set cutting type to PLATFORM (B).
12. Set appropriate HEADER WIDTH (C) and HEADER
USAGE (D).
PREDELIVERY INSPECTION
To Next Page
Loading...
