cigarettes when cleaning the transparent cap of the water separator.
• If the fuel spills when water is drained from the water separator or the water separator is
replaced, be sure to wipe it off.
inside the transparent cap and drain any water or dust accumulated inside.
• If water accumulates in the water separator transparent cap, it is assumed that water is
also mixed in the fuel tank. Drain water and dust mixed in the fuel tank.
•
If water in the water separator transparent cap freezes, check that frozen water melts
completely before draining water.
[Water draining]
• The water separator is integral with the fuel filter, and inspect
the water separator of the main filter (1) and sub filter (2),
respectively.
• Prepare for a container which receives drained water.
[Main filter]
1. Place the machine on a level surface.
2. Open the right cover of the machine body.
3. Inspect the transparent cap (2) and check if water and
deposits accumulate in the transparent cap (2).
4. If water accumulates in the transparent cap (2), drain water
in the following steps.
(1) Set a container which receives drained water under
the drain plug (4).
(2) loosen the air bleeder plug (3).
(3) Loosen the drain plug (4) to drain water accumulated
inside.
(4) After water is drained, be sure to tighten the air
bleeder plug (3) and drain plug (4) to conduct air
bleeding of fuel.（See P. 3 - 141)
Tightening torque
Air bleeding plug (3) 10.0 N･m {1.0 kgf･m}
Drain plug (4) 2.0 N･m {0.2 kgf･m}
To Next Page
