Unless these precautions in travelling are observed, serious physical injury may be caused.
[1] PRECAUTIONS IN TRAVELLING
Travelling over boulder stones or a stump can give a big
impact to the machine (especially undercarriage), causing
breakage.
Avoid or remove the obstacles so as not to travel over it
whenever possible.
If you cannot avoid travelling over obstacles, be sure to take
the “travelling posture” to lower the centre of gravity, and
reduce the travelling speed as much as possible so that the
machine will go over the obstacles at the centre of the crawlers.
See "OPERATION 3.7 MACHINE TRAVELLING POSTURE"
for the travelling posture of the machine.
[2] PRECAUTIONS IN TRAVELLING AT HIGH SPEED
When travelling on a bumpy roadbed or a bumpy road with a lot of boulder stones, turn the travelling
speed to the low speed "1st speed". When travelling at high speed "2nd speed" be sure to face the
idler to the travelling direction.
To change the travelling speed, operate the travelling speed selector switch (1).The travelling speed
(1st speed, 2nd speed) is displayed on the travelling speed monitor screen (2).
To Next Page
