172
3.16 CRANE WORK POSTURE
When moving to the crane work from the state of "Operation
3.15 Operation Before Crane Work", put the crane into the
crane work posture in the following manner.
1. Operate the right work equipment operation lever (1) to the
"HOIST" side (pull toward you) to hoist the hook block.
At this time, do not overhoist the hook block.
If overhoisted, the hook block is in a state of being
overwound.
2. Operate the right work equipment operation lever (1) to
"LOWER" side (push to the right side) to lower the boom.
At this time, be careful not to allow the hook block to fall
sideways on the ground.
3. Repeat the operation in Section 1 and 2 and put the
machine into the work posture shown in the right figure.
To Next Page
