Maeda CC1485S-1 - Preparing for Safe Operation

15
1.2 PREPARING FOR SAFE OPERATION
PROVIDE SAFETY DEVICES FOR SURE
• Check to ensure that all guards, covers, mirrors and rear-view camera are attached properly.
Repair immediately if damaged.
• Understand how to use the safety devices well and use properly.
• Do not detach the safety devices under any circumstances. Keep control to achieve proper
function all the time.
• Improper use of the safety devices may lead to serious accidents.
• Do not rely too much on the safety devices whilst operating.
PREPARE FOR ABNORMALITY
• Make sure to carry out inspections and maintenances, and
make an effort to prevent accidents before happening.
• Whenever you feel an abnormality in the Machine, abort the
operation immediately, ensure safety and report to the
manager.
•
Assign in advance who takes which solution to prevent
secondary accident.
•
Never operate the Machine when fuel or hydraulic oil is
leaking from the Machine. Report
the manager about the
abnormality, and repair the leaking point of the
fuel/hydraulic oil completely before use.
The fuel for this Machine is diesel fuel. Be especially careful
for the presence of fuel leak.
•
Before leaving the Machine, lower the hoisted load to the
ground, stop the engine and pull out the starter key.
TEMPORARY STORAGE WHEN ABNORMALITY IS FOUND WITHIN MACHINE
In case the Machine is found with an abnormality and is
therefore stored temporarily waiting for service, apply
following measures to notify all persons in the office that "the
use is prohibited due to failure."
•
Put on warning tags on the operation lever and other
applicable parts.
Write clearly the information such as abnormality contents,
name and contact of the storage manager, and the term of
storage.
• Keep it immovable when parking by, for instance, putting the
blocks on the rubber tracks as pawls.
• Pull out the engine key and keep it with you.
WEAR PROTECTIVE EQUIPMENT AND CLOTHES SUITABLE FOR WORK
• Always put on a helmet, safety shoes and safety belt.
• Make sure to wear the necessary protective equipment
suitable for the relevant working condition.
• Do not wear loose garments or access
ories as these may
get caught on an operation lever or any protrusions which
could lead to unexpected movement of the Machine.