201
5.1.3 UNLOADING
1. Select a level and firm road surface for unloading the
machine. In addition, keep enough distance from the
roadside.
2. Brake the trailer securely. Place wheel blocks next to the
wheels of the trailer to secure the trailer.
3. Ramp boards must be suitably aligned so that the machine
rests in the centre of the trailer.
distance for the right and left with respect to the center of
the trailer.
• The instalaltion angle of the ramp boards must be 15
degrees or less.
•
Securely hang the hooks of the ramp boards on the hooks
of the trailer.
•
If the ramp boards are bent by the machine weight, place
a block such as lumber under the ramp boards to prevent
bending.
4. Remove the chain or wire rope which fixes the machine.
5. Start the engine.
Warm up the engine enough in cold climate.
6. Place the lock lever at the free position (F).
7. Turn the travelling speed range to low speed travelling (1st
speed).
To change the travelling speed range, press the travelling
speed 1st speed/2nd speed selector switch.
8. Set the engine speed to low speed with the fuel adjustment
dial.
9. Fix the direction toward the ramp boards and slowly travel
for unloading. At this time, do not operate any other lever
than travelling levers on the ramp boards.
To Next Page
