If you did not perform antirust operation monthly during the long-term storage, contact us or our
sales service agency before using the machine.
Perform the following before using the machine after the long-term storage.
• Remove the drain plug of the fuel tank, hydraulic oil tank, and engine oil pan to drain the water
mixed in.
• Refuel, grease, and change the oil without fail.
• Wipe off grease applied to the exposed section of the piston rod of the hydraulic cylinder.
• Remove the cover over the battery (install the battery to the machine if dismounted for storage).
Check the electrolyte level and specific gravity, and then connect the negative side of the battery
cable.
• Carefully perform the check before starting operation and perform warm-up operation. Carefully
check the various parts of the machine.
To Next Page
