Maeda CC1485S-1 - Maintenance Procedures; Initial 500 Hour Maintenance; Initial 500-Hour Maintenance; Pre-Operation Inspection

241
10. MAINTENANCE PROCEDURE
10.1 INITIAL 500 HOUR MAINTENANCE
The following maintenance should be performed after 500hours of operation for the 1st
maintenance servicing only, of a new machine.
[1] OIL REPLACEMENT IN WINCH REDUCTION GEAR CASE
See "10.7 MAINTENANCE EVERY 1000 HOURS " for maintenance places and procedure.
10.2 PRE-OPERATION INSPECTION
Inspections described in this section should be conducted before the first engine start-up of the
day.
See “9. LIST OF ITEMS FOR INSPECTION AND MAINTENANCE” for the items of pre-operation
inspection.
See "OPERATION 3.1 PRE-OPERATION INSPECTION" for maintenance places and procedure
of pre-operation inspection.