Maeda CC1485S-1 - Setting of Operating Conditions

347
5.3 SETTING OF OPERATING CONDITIONS
CAUTION
When the Fly-jib is installed to the main boom tip, the machine turns into the following
operation state.
• The rated total load value displayed on the monitor is switched to the one for the Fly-jib.
• When the Fly-jib tilt angle is set to 0 or 20 degrees, load hoisting operation is not available
where the boom angle is “45 degrees” or less. The moment limiter emits an over-load
warning.
• When the Fly-jib tilt angle is set to 40 or 60 degrees, load hoisting operation is not available
where the boom angle is “65 degrees” or less. The moment limiter emits an over-load
warning.
• The raising and lowering operation of the winch is fixed to the low speed (1st speed).
•
The number of falls of hook selector button is disabled and the number of falls is fixed to
“Single fall”.