160
[2] MOVING BACKWARD
1. Place the lock lever (4) at the "Free" position.
2. Operate the right and left travelling levers (5) as follows.
• When the sprocket (A) is rearward of the machine body
Pull the travelling levers (5) slowly toward you to start
moving.
• When the sprocket (A) is forward of the machine body
Push the travelling levers (5) slowly forward to start
moving.
• Check that the travelling alarm sounds properly during travelling.
If the travelling alarm does not sound, contact us or our sales service agency for repair.
• When the machine does not travel at proper speed at low temperature, perform sufficient warm-
up operation. When the machine does not travel at proper speed because the undercarriage is
clogged with sand and mud, remove sand and mud.
• When the hook block is in the simple stowage position, it may be loosened by vibration during
travelling. In such a case, perform the hook block simple stowage operation again.
[3] STOPPING
Avoid sudden stops and try to stop with a safety margin
whenever possible.
• Place the right and left travelling levers (5) at the neutral
position (N).
The machine stops.
To Next Page
