277
6. Clean the filter base, thinly apply oil on the gasket face of the new filter and refit it on the filter
base.
7. When reinstalling the filter cartridge, tighten it for 3/4 of a turn after the gasket face comes in
contact with the sealing face of the filter base.
· Excessive tightening of filter cartridge may damage the gasket mating surface, leading to the
leakage of fuel. Also a loose fitting may cause fuel leakage around the gasket. Always
observe the tightening angle.
·
When using a filter wrench for the tightening, pay adequate attention not to generate
scratches and dents on the filter.
8. Attach the cover (1) on top of the hydraulic oil tank.
9. To ensure air venting, run the engine at idle for 10 minutes after starting it.
10. Stop the engine.
After stopping the engine let it stand still for 5 minutes or
more before restarting.
This allows the air bubbles entrapped in the oil of the
hydraulic oil tank to discharge into the atmosphere.
11. Check for any oil leakage, and cleanly wipe off any spilt oil.
To Next Page
