Always observe the following to prevent serious injuries and
accidental death when moving the Machine.
• Set the Machine to the travelling posture in the right figure.
Refer to the preceding subsection "CAUTIONS ON
MACHINE FORWARDING/REVERSING AND SLEWING".
•
Do not attempt looking sideways or other dangerous act
when driving.
• Do not over speed, start moving/stopping/slewing
suddenly, or meander since such acts are dangerous.
• During traveling, keep an adequate distance from persons,
structures and other machines to prevent any contact
accident.
• When running on a rough terrain or a steep slope, be sure
to turn the automatic deceleration switch OFF (for
Operating the Machine while the switch is
turned ON raises the engine revolution speed, and the
vehicle speed may suddenly be increased.
• Avoid moving over any obstacle. Travel as slow
ly as
possible when moving over an obstacle for unavoidable
reason. Since the Machine tends to tumble more easily in
the lateral direction rather than in the longitudinal direction,
never attempt to move over an obstacle that will cause the
Machine to inclined to leftward or rightward.
• When traveling on a rough terrain, keep the vehicle speed
at low level to avoid tumbling and also avoid any abrupt
change of traveling direction. Such may cause the Machine
to lose balance or damage the Machine or nearby object.
•
When running on a bridge or crossing over a structure,
check the withstand strength of the bridge or viaduct
against the Machine mass beforehand.
Further, when
running on a public road, check with the competent
authorities and follow their instructions.
•
When operating the Machine in a place where machine
height is restricted such as in a tunnel, in a building, under
an overpass or cables, pay close attention to prevent the
Machine and crane from coming into contact of those
objects and operate the Machine slowly.
To Next Page
Loading...
