1-8
This code can be entered to access service
mode without removing the console. It
only functions on dryers set up for 0 vend
price without any Special Pricing set-up,
and the Coin/Debit Option must be set to
“J._d”. If the dryer is not in failure mode,
the door must be opened to proceed.
Service Access Code contains 6 steps and
some are timed. Using the three buttons
(numbered 1, 2, and 3 from left to right):
Press 2 for longer than 2 seconds but less
than 10 seconds.
Press 1 & 3 together for 2 seconds, then
release. Displays S 3.
Press 1 & 2 together, then release.
Displays S 4.
Press 2 & 3 together, then release.
Displays S 5.
Press 2, then release.
Displays “codE”.
Wait at least 2 seconds, but not more than
15 seconds, then press in succession: 3, 2,
1, 3.
If the Service Access Code
procedure is not completed properly, as
noted above, there is a 15 second delay
before it can be attempted again.
There are 3 options to exit from the Service
Mode:
From Set-up Code 8, press button #1 for 4
seconds.
Wait 2 minutes without touching any buttons
(without diagnostic modes running).
Power down the dryer, then reapply power.
n
1.
2.
3.
4.
5.
6.
1.
2.
3.
Insert access key and turn
counter-clockwise.
The console must not be
opened unless power is removed from the
dryer.
Unplug dryer or disconnect power.
Open console, disconnect plug on AA1,
close console.
Plug in dryer or reconnect power.
n
1.
2.
3.
To Next Page
