WIRING DIAGRAMS
Page 2D-30 90-884294 OCTOBER 2001
CAL1
Calibration
Cal1
Display Calibrations:
•Trim Pop up Screen (On or Off)
•Trim Calibration
•English or Metric Units Selection
•Range Units Selection
•(On or Off) Depth, Trim, Engine Temperature, Oil Pressure, Oil
Temperature, Water Pressure, Volts, Engine Hours, and Data
Simulator pages.
NOTE: NOT ALL SCREENS MAY APPLY TO YOUR ENGINE TYPE.
CAL1
HEADER SCREEN
1. Turn ignition key to the on position.
2. Press and hold
and for 3 seconds to bring up the
Cal1
calibration screen.
Release the buttons to enter
Cal1
.
3. Press the
button to advance through the
Cal1
calibration functions.
4. Press and hold
and for 3 seconds to save changes and exit the
Cal1
cal-
ibration screen.
Press the button to move to the next calibration screen.
NOTE: Pressing the button while in this header screen, will “transfer” you straight into
Cal2.
TRIM POP UP SCREEN (ON OR OFF)
If you want the power trim display screen to pop up as you trim the propulsion unit, cali-
brate as follows: With the pop up screen displayed and the number “flashing”, press the
button to select 1=ON or 0=off.
Trim
Press the button to save and move to the next function.
Set the trim sensor as follows:
Calibration 0.0 – The word “Trim” and down arrow should be blinking. Use the trim switch and
trim the unit to the full Down/In position. Press the
button to save. Press the
button to advance to the Calibration 10.0 setting.
Trim
To Next Page
Loading...
