OUTBOARD MOTOR INSTALLATION
Page 1D-6 90-884294 OCTOBER 2001
Electrical, Hoses and Control Cables
IMPORTANT: Warning Horn Requirement – The remote control or key switch as-
sembly must be wired with a warning horn. This warning horn is used with the en-
gine warning system.
Installation Note
Open the front clamp assembly.
57841
Remote Wiring Harness
1. Connect wiring. Place harness into the holder.
59027
GRN/WHT
BLU/WHT
BRN/WHT
TAN
BLU/WHT
GRN/WHT
a
TAN
BRN/WHT
b
c
d
a-Power Trim Connections
b-Wire Connection For Non SmartCraft Water Temp Gauge
c-Connection For Non SmartCraft Analog Trim Gauge
d-Harness Holder (Located in Cowl) – Place Wiring Harness and Battery
Cables into Holder
To Next Page
Loading...
