LEFT HAND NON-RATCHETING
Page 6B-96 90-884294 OCTOBER 2001
19. Bend one tab aft (outward) into a space between two of the notches of the retainer.
Bend all the remaining tabs forward (inward).
70490
c
b
a
d
a-Bearing Carrier
b-Tab
c-Retainer Notches
d-Alignment Tabs (Bend Inward)
Oil Seal Carrier Assembly
Installation
NOTE: Apply hand pressure only to install the oil seal carrier into position. Do not hammer
it into position.
1. Lubricate the oil seal carrier, oil seal lips, space between seals and O-ring with 2-4-C
Marine Lubricant with Teflon and install the oil seal carrier over the drive shaft and into
the gear case.
70501
a
b
c
a-Oil Seal Carrier
b-Oil Seal Lips
c-O-ring
To Next Page
Loading...
