Mercury 225 EFI - Gear Location;Backlashes;Checking and Adjustment; Drive Shaft - Bearing Preload Tool

RIGHT HAND NON-RATCHETING
Page 6A-54 90-884294 OCTOBER 2001
Gear Location/Backlashes/Checking and Adjustment
Drive Shaft - Bearing Preload Tool
INSTALLATION
1. Install the components from the Bearing Preload Tool Kit (91-14311A2), over the drive
shaft in the order shown.
70496
a
b
c
d
e
f
g
d
a-Top Nut with Threaded Pipe
b-Nut
c-Spring
d-Thrust Washer (2 Required) (12-18448)
e-Thrust Bearing
f-Thrust Washer
g-Plate
2. Pull up on the drive shaft and tighten the two (2) allen screws in the top nut of the bear-
ing preload tool.
57936
a
a
a-Allen Screws