RIGHT HAND NON-RATCHETING
Page 6A-16 90-884294 OCTOBER 2001
4. Inspect impeller side seal surfaces and ends of impeller blades for cracks, tears and
wear. Replace impeller if any of these conditions are found.
5. Inspect impeller bonding to impeller hub.
6. Inspect impeller for glazed or melted appearance (caused by operation without suffi-
cient water supply). Replace impeller if any of these conditions exist.
70500
a
b
a-Impeller
b-Hub
IMPORTANT: When completing gear housing repairs, that require removal of water
pump impeller, it is recommended that the impeller be replaced. If it is necessary,
however, to re-use impeller, DO NOT install in reverse to original rotation, or prema-
ture impeller failure will occur.
IMPORTANT: It is recommended that all seals and gaskets be replaced (as a normal
repair procedure) to assure effective repair.
Oil Seal Carrier Assembly
REMOVAL
1. Remove the oil seal carrier from the gear housing. It may be necessary to gently pry
up on it with two screwdrivers.
57940
b
b
a
a-Oil Seal Carrier
b-Screwdrivers
To Next Page
Loading...
