Mercury 225 EFI - Reassembly and Installation

CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING
Page 5A-12 90-884294 OCTOBER 2001
10. Remove lower mount nuts and rubber caps.
52308
a
b
a-Lower Mount Nuts
b-Rubber Caps
11. Remove drive shaft housing from swivel bracket by pulling alternately from top to bot-
tom on housing.
12. Remove upper and lower mounts by lifting them out of drive shaft housing.
Reassembly and Installation
1. Apply a thin coat of 2-4-C Marine Lubricant with Teflon onto inside portion of exhaust
tube seal and water tube grommet.
2. Install exhaust tube seal into driveshaft housing with tapered side of seal facing up.
95
2-4-C Marine Lubricant with Teflon
95
d
b
c
a
a-Exhaust Tube Seal
b-Driveshaft Housing
c-Water Tube Grommet
d-Leather Bumper