CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING
90-884294 OCTOBER 2001 Page 5A-11
6. While tilting adaptor plate/exhaust tube assembly, use a piece of hardwood and a mal-
let to loosen gasket adhesion. Remove exhaust tube.
c
a
b
a-Hardwood
b-Adaptor Plate
c-Exhaust Tube
7. Remove all gasket material from driveshaft housing and related components.
8. Remove screw, which secure lower mount cover to drive shaft housing, and remove
cover.
9. Remove bolts securing lower mount retainers to drive shaft housing. Remove retain-
ers.
52307
52308
a
b
c
d
a-Screw
b-Cover
c-Bolts
d-Lower Mount Retainer
(1 each side)
To Next Page
Loading...
