RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-63
Drive Shaft - Bearing Preload Tool
REMOVAL
CAUTION
Before loosening the top nut allen screws of the bearing preload tool, screw the
bottom nut up as close as possible to the top nut.
1. Remove the dial indicator and its supporting tooling.
2. Screw the bottom nut of the bearing preload tool until it is as close as possible to top
nut.
3. Loosen the allen screws in the top nut.
4. Remove all components including the water pump face plate.
57936
a
b
c
a-Top Nut (with allen screws)
b-Bottom Nut
c-Water Pump Face Plate
To Next Page
Loading...
