Mercury 225 EFI - Propeller Shaft Assembly and Forward Gear Bearing Cup

RIGHT HAND NON-RATCHETING
Page 6A-32 90-884294 OCTOBER 2001
Propeller Shaft Assembly and Forward Gear Bearing Cup
REMOVAL
1. Tilt the propeller shaft to the port side of the gear housing and remove the shaft by
pulling it straight up and out.
a
b
c
d
58016
a-Propeller Shaft Assembly
b-Shift Spool
c-Shift Crank
d-Thrust Washer (Reverse Gear)
2. Remove the forward gear bearing cup and shims. Measure and make note of the shim
thickness. If the shims are not damaged, they may be reused.
50780
a
b
c
e
d
f
g
h
a-Puller Shaft (91-31229)
b-Nut (11-24156)
c-Washer (91-34961)
d-Guide Plate (91-816243)
e-Puller Head (from Slide Hammer Puller Kit 91-34569A1)
f-Jaws (from Slide Hammer Puller Kit)
g-Bearing Cup
h-Shims