FUEL INJECTION
90-884294 Page 3B-53OCTOBER 2001
Vapor Separator Reassembly
NOTE: Inspect VST cover gasket with sealing bead for cuts or abrasions. Replace if nec-
essary. Inspect fuel pump seal in VST cover for cuts or abrasions. Replace if necessary.
1. Install gasket w/sealing bead onto vapor separator cover.
2. Secure float, needle and pivot pin assembly to separator cover with screw. Torque
screw to 10 lb. in. (1.0 Nm)
3. Apply 2-4-C Marine Lubricant with Teflon to lips of seal in separator cover.
58787
b
a
c
d
58783
e
a-Screw [Torque to 10 lb. in. (1.0 Nm)]
b-Float
c-Gasket
d-Sealing Bead
e-Seal (Seal shoulder faces OUT)
4. Connect electrical harness to fuel pump. Inspect fuel pump filter screen for debris. Re-
move screen and clean as required.
5. Seat fuel pump and harness into separator cover being careful not to pinch harness.
58786
a
b
c
d
a-Harness
b-Filter
c-Seal
d-Fuel Pump
To Next Page
Loading...
