IGNITION
Page 2A-30 90-884294 OCTOBER 2001
Ignition Component Removal and Installation
Flywheel Removal
1. Remove flywheel cover off engine.
2. Remove alternator belt.
3. While holding flywheel with Flywheel Holder (91-52344), remove flywheel nut and
washer.
59071
b
a
a-Flywheel Holder (91-52344)
b-Flywheel
4. Install Flywheel Puller (91-849154T1) into flywheel.
CAUTION
Do not hammer on end of puller center bolt to remove flywheel, or damage may
result to crankshaft or bearings. Do not use heat to aid flywheel removal as fly-
wheel may be damaged.
59072
b
a
a-Flywheel
b-Flywheel Puller (91-849154T1)
To Next Page
Loading...
