POWERHEAD
90-884294 OCTOBER 2001 Page 4A-47
Cleaning and Inspection
Cylinder Block and Crankcase Cover
IMPORTANT: Crankcase cover and cylinder block are a matched, line-bored assem-
bly and never should be mismatched by using a different crankcase cover or cylinder
block.
CAUTION
If crankcase cover or cylinder block is to be submerged in a very strong cleaning
solution, it will be necessary to remove the crankcase cover/cylinder block bleed
system from crankcase cover/cylinder block to prevent damage to hoses and check
valves.
1. Thoroughly clean cylinder block and crankcase cover. Be sure that all sealant and old
gaskets are removed from matching surfaces. Be sure that carbon deposits are re-
moved from exhaust ports.
2. Inspect cylinder block and crankcase cover for cracks or fractures.
3. Check gasket surfaces for nicks, deep grooves, cracks and distortion that could cause
compression leakages.
4. Check all water and oil passages in cylinder block and crankcase cover to be sure that
they are not obstructed and that plugs are in place and tight.
Special Service Information
Grooves in Cylinder Block Caused By Crankshaft Sealing Rings
Grooves in cylinder block caused by crankshaft sealing rings are not a problem, except if
installing a new crankshaft and the new sealing rings on crankshaft do not line up with exist-
ing grooves in cylinder block. If installing a new crankshaft, refer to crankshaft installation,
Powerhead Reassembly section to determine if powerhead can be used.
To Next Page
Loading...
Need help?
General
