RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-67
Oil Seal Carrier Assembly
Installation
NOTE: Apply hand pressure only to install the oil seal carrier into position. Do not hammer
it into position.
1. Lubricate the oil seal carrier oil seal lips, space between seals and O-ring with 2-4-C
Marine Lubricant with Teflon and install the oil seal carrier over the drive shaft and into
the gear case.
70501
a
b
c
a-Oil Seal Carrier
b-Oil Seal Lips
c-O-ring
Water Pump Assembly
Installation
NOTE: The gaskets/face plate hole pattern is not symmetrical. If the holes of the gaskets/
face plate do not align with the screw holes of the gear case and/or each other, one or
more of the parts is upside down. Determine which part(s) is (are) upside down and turn
the appropriate part(s) over.
1. Install the small hole gasket then the face plate followed by the large hole gasket onto
the gear case.
58011
a
b
c
a-Small Hole gasket
b-Face Plate
c-Large Hole Gasket (GRAY sealing ring faces up)
To Next Page
Loading...
