POWERHEAD
90-884294 OCTOBER 2001 Page 4A-85
Throttle Cable
INSTALLATION
1. Position remote control into neutral.
N
2. Attach throttle cable to the throttle lever. Secure with washer and locknut.
a
b
a-Nylon Washer
b-Locknut – Tighten locknut then back off locknut 1/4 turn
3. Adjust the cable barrel so that the installed throttle cable will hold the idle stop screw
against the stop.
a
b
a-Cable Barrel – Adjust To Hold Idle Stop Screw Against Stop
b-Idle Stop Screw
To Next Page
Loading...
