LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-57
Pinion Bearing
INSTALLATION
IMPORTANT: Install only a new pinion bearing. Do not reinstall a pinion bearing that
has been previously removed from a gear housing.
1. Lubricate the bore into which the pinion bearing is to be installed with Premium Gear
Lubricant.
2. Position the new pinion bearing (with the cardboard shipping sleeve in place) onto the
driver head, with the lettered and numbered side of the bearing oriented upward.
3. Insert the driver with the bearing assembly, into position (by way of the propeller shaft
bore) at the drive shaft bore as shown.
70615
87
Premium Gear Lubricant
87
c
d
e
g
f
a
b
a-Drive Shaft Pinion Bearing (With Cardboard Shipping Sleeve)
b-Driver Head (91-38628)
c-Puller Shaft (91-31229)
d-Washer (12-34961)
e-Nut (11-24156)
f-Pilot Washer (91-36571)
g-Puller Plate (91-29310)
4. Install the bearing by screwing down the nut until the bearing is fully seated against
the bore shoulder.
To Next Page
Loading...
