RIGHT HAND NON-RATCHETING
Page 6A-40 90-884294 OCTOBER 2001
Propeller Shaft Assembly
COMPONENT REASSEMBLY
1. Install the sliding clutch on the propeller shaft. Align cross pin holes in the clutch with
the slot in the propeller shaft.
2. Assemble the forward gear assembly to the propeller shaft.
3. Assemble the shift spool assembly to the propeller shaft being sure to align the cross
pin hole of the shift spool shaft with the clutch.
4. Assemble the cross pin through the sliding clutch, through the propeller shaft and
through the shift spool shaft hole.
5. Install detent pin in 3rd hole in clutch.
6. Assemble the cross pin retaining spring over the propeller end of the propeller shaft
and wind it around the clutch over the cross pin hole. Be careful not to distort the spring
while assembling it. Make sure that the spring is wound on so that it does not
cross over on itself and that it lies flat against the clutch once it is assembled.
If it does not lie flat against the clutch, a new spring must be installed.
58017
a
b
c
d
e
f
g
a-Sliding Clutch
b-Forward Gear Assembly
c-Cross Pin (hidden)
d-Propeller Shaft
e-Spool and Actuating Shaft Assembly
f-Cross Pin Retaining Spring
g-Detent Pin (hidden)
To Next Page
Loading...
