LEFT HAND NON-RATCHETING
Page 6B-58 90-884294 OCTOBER 2001
Reverse Gear Bearing Adaptor Assembly
INSTALLATION
NOTE: If the reverse gear, reverse gear adaptor, large thrust bearing, or bearing race in
the gear housing were not replaced, install the same shim(s) (or the same thickness of
shim(s) that were taken out when adaptor was removed. If the reverse gear, reverse gear
adaptor, large thrust bearing, bearing race, or gear housing were replaced, install 0.008
in. (0.51 mm) of shims.
1. Lubricate the bore into which the reverse gear bearing adaptor is to be installed with
2-4-C Marine Lubricant with Teflon.
2. Place the shim(s) into reverse bore of gear housing.
3. Position the bearing adaptor in the gear housing.
50781
95
2-4-C Marine Lubricant with Teflon
95
a
b
a-Bearing Adaptor
b-Shims
IMPORTANT: The appearance of the forward and reverse gear is almost identical.
The forward gear has a shorter hub and is slightly smaller in diameter.
50885
REVERSE
FORWARD
3.75″ (9.5cm)
4″ (10.2cm)
a
a-Shorter Hub
To Next Page
Loading...
