CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING
Page 5A-8 90-884294 OCTOBER 2001
Drive Shaft Housing and Dyna-Float Suspension
Refer to “Powerhead Removal” section to remove powerhead. Refer to “Lower Unit
Removal” in this section to remove lower unit.
Removal and Disassembly
1. Remove shift shaft from driveshaft housing by pulling straight up on shaft.
2. Remove power trim wiring harness from exhaust adaptor plate.
3. Remove 3 bolts which secure upper mount cover to adaptor plate. Remove cover.
58005
a
b
c
d
e
a-Shift Shaft Linkage
b-Wiring Harness
c-Adaptor Plate
d-Bolts
e-Upper Mount Cover
To Next Page
Loading...
