RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-53
8. Install the bearing carrier into the gear housing backwards to hold the propeller shaft
and the pinion nut adaptor in position.
9. Torque the pinion nut to 75 lb. ft. (102 Nm) by turning the drive shaft using the drive
shaft nut wrench and torque wrench.
57950
b
c
a
a-Pinion Nut Adapter (91-61067A2)
b-Drive Shaft Nut Wrench (91-56775)
c-Bearing Carrier (installed backwards)
10. Remove the bearing carrier, pinion nut adapter and drive shaft nut wrench.
11. Torque the retainer to 100 lb. ft. (135 N·m).
57935
a
a-Drive Shaft Bearing Retainer Wrench (91-43506)
To Next Page
Loading...
