LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-95
17. Fill the bearing carrier retainer nut threads and corresponding gear housing threads
(360°) with 2-4-C Marine Lubricant with Teflon. Start the retainer into the gear housing
threads and screw it down fully by hand.
70715
95
2-4-C Marine Lubricant with Teflon
95
a
a-Bearing Carrier Retainer
IMPORTANT: Before torquing bearing carrier retainer, gear case must be bolted to
drive shaft housing or securely fastened in a gear case holding fixture to avoid pos-
sible damage to gear housing.
18. Torque the bearing carrier retainer to 210 lb. ft. (284.7 N·m). If one tab does not align
up in space between two of the notches, continue to tighten retainer until alignment
is achieved. DO NOT loosen retainer to achieve alignment.
23355
a
a-Bearing Carrier Retainer Wrench (91-61069)
To Next Page
Loading...
