CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING
90-884294 OCTOBER 2001 Page 5A-3
Swivel Bracket and Steering Arm
TORQUE
.
NO.
QTY. DESCRIPTION lb. in. lb. ft. N·m
1 1 SWIVEL BRACKET
2 1 O RING
3 2 BUSHING
4 1 SPACER
5 1 OIL SEAL (LOWER)
6 2 GREASE FITTING 85 9.5
7 2 BUSHING
8 1 THRUST WASHER
1 BOTTOM YOKE (LONG – CARBON STEEL)
9
1 BOTTOM YOKE (XL–STAINLESS STEEL)
10 1 RETAINING RING
11 2 STRIKER PLATE
12 2 LOCKWASHER
13 2 NUT 25 34
14 2 SCREW (1/4-28 x 1/2 IN.) 100 11.5
15 1 DECAL-Serial Overlaminate
16 1 TRIM SENDER
17 2 SCREW (10-24 x 3/4 IN.) 15 1.7
18 2 LOCKWASHER
19 2 WASHER
1 SWIVEL PIN/STEERING ARM (LONG – CARBON STEEL)
20
1 SWIVEL PIN/STEERING ARM(XL–STAINLESS STEEL)
21 2 SCREW (M12 x 1.75 x 190)
22 1 BUMPER
23 2 UPPER MOUNT
24 2 WASHER
25 2 WASHER
26 2 NUT 50 68
27 1 CLAMP
28 3 SCREW (M8 x 35) 20 27
29 1 STEERING LINK ASSEMBLY
30 1 SCREW 20 27
31 2 NUT (.375-24)
32 2 WASHER
NOTE:
A –
Torque nut to 120 lb. in. (13.5 Nm) and then back off 1/4 turn.
NOTE:
B –
Torque nut to 20 lb. ft. (27 Nm)
To Next Page
Loading...
