POWER TRIM - DESIGN II
90-884294 OCTOBER 2001 Page 5B-5
Power Trim Components (Oildyne)
TORQUE
.
NO.
QTY. DESCRIPTION lb-in lb-ft Nm.
– 1 POWER TRIM ASSEMBLY–Complete
1 1 TRIM MOTOR
2 1 ARMATURE
3 1 END FRAME
4 2 SCREW (M6 x 30) 80 9
5 2 LOCKWASHER
6 1 DRIVE SHAFT
7 1 CHECK VALVE KIT 120 13.5
8 1 RELIEF VALVE ASSEMBLY 22 2.5
9 1 SHAFT KIT (Includes. Ref. #26)
10 1 GROOVE PIN
11 1 TILT CYLINDER ASSEMBLY
12 1 END CAP (Includes. Ref. #26) 45 61
13 1 O RING KIT (Includes. Ref. #26)
14 1 SHOCK ROD KIT 95 129
15 1 MEMORY PISTON
16 1 CHECK VALVE REPAIR KIT (Includes. Ref. #26)
17 1 STARBOARD TRIM ROD
18 1 PORT TRIM ROD
19 2 END CAP TRIM ROD 70 95
20 1 RESERVOIR KIT
21 1 PLUG KIT 22 2.5
22 4 SCREW (M6 x 14) 60 7
23 4 WASHER
24 1 PUMP KIT
25 1 POWER TRIM REPAIR KIT
26 1 GROOVE PIN
27 6 SCREW (M10 x 30) 45 61
28 6 WASHER
29 1 ANODE
30 2 SCREW (M6 x 25) 70 8
31 2 WASHER
32 1 SHAFT
33 1 C WASHER
34 2 CLIP
35 2 SCREW (10-16 x 5/8) Drive Tight
36 1 STA-STRAP
37 1 CONDUIT [12 IN. (30.5 CM)]
NOTE: Lubricate all o-rings with ATF Dexron III or Power Trim and Steering Fluid.
To Next Page
Loading...
