POWER TRIM - DESIGN II
Page 5B-30 90-884294 OCTOBER 2001
IMPORTANT: Cross pin should not be reused. Replace with new cross pin.
NOTE: 6 trim mounting bolts should not be reused. Replace with new patch lock bolts.
6. Drive out cross pin, push out upper swivel pin, and remove 3 bolts and washers in port
clamp bracket.
58452
b
b
a
a
58444
c
a-Cross Pin
b-Upper Swivel Pin
c-Port Transom Bracket Bolts and Washers (3). Remove to release Trim
System from Outboard.
7. Remove 3 bolts and washers and in starboard transom bracket.
58453
a
c
d
a
b
a-Transom Mount Bolts (2)
b-Tilt Tube Nut (flush with end of thread)
c-Screws (3)
d-Washers (3)
8. Remove outboard transom mounting bolts and loosen tilt tube nut until nut is flush with
end of tilt tube thread. Remove system from outboard.
To Next Page
Loading...
