POWER TRIM - DESIGN II
Page 5B-32 90-884294 OCTOBER 2001
6. Connect trim motor wires to relays. Refer to Wiring Diagrams in this manual. Route
trim wires as specified in this manual.
NOTE: The 2 power leads going to the trim motor should be encapsulated with conduit
tubing.
56921
56922
a
a-Conduit Tubing
7. Apply marine sealer to shanks of mount bolts and install transom mount bolts.
IMPORTANT: Do not use an impact driver to tighten transom mount bolts.
Apply marine sealer to threads of mount bolts. Secure with flat washers and locknuts. Be
sure installation is watertight.
8. Tighten tilt tube nut securely.
IMPORTANT: Outboards equipped with through-the-tilt-tube steering: Tighten
steering cable retaining nut securely to tilt tube.
58454
a
a-Steering Cable Retaining Nut
WARNING
Electrical wires passing through cowl openings must be protected from chafing
or being cut. Follow the recommended procedures outlined in Section 1D of this
Manual. Failure to protect wires as described could result in electrical system fail-
ure and/or injury to occupants of boat.
To Next Page
Loading...
